Water Meter Firmware

Water Meter Relay Firmware

Firmware archive for Water Meter Relay. Versions include updates for relay logic, thresholds, Cloud connection and device stability.

Firmware download

Firmware

WMR-1.4.0.bin

  • Fixed an issue where the reading angle setting was not applied correctly.
  • The default reading angle has changed from 16° to 27°. If you experience level-reading issues after the update, adjust the angle until the measurement is correct. Reliability increases with the reading angle, but the maximum usable angle may be limited by obstacles such as the tank walls and float. See the Angle Water Meter page.
  • Improved device startup-delay management for more reliable reconnection at power-on, such as after a power outage. By default, the device now waits 3 minutes at startup for the WiFi network to become available again.
  • Fixed an issue where level readings returned nonsensical values in the event of an incorrect configuration when viewed locally. This bug did not affect the cloud service.
  • Improved device reliability during extended use.

MD5: 68353fbea84684688d8f4998815fc743

Firmware

WMR-1.3.0.bin

  • Nuovo in Impostazioni Relay: Range Mode introduced.
  • Water Meter Relay can maintain the relay status until the opposite threshold is reached.
  • To enable this mode, open the configuration portal, go to Relay Settings, enable both minimum and maximum thresholds and enable the “Range Mode” option.
  • By default the behaviour is activation below the minimum threshold and deactivation at the maximum threshold; it can be inverted by selecting MIN: OFF / MAX: ON.

MD5: 56dd3e824ba4d8453298e85af0edc3f4

Firmware

WMR-1.2.1.bin

  • New in Device Settings: option to delay device startup at power-on.
  • Useful to prevent AP mode from being enabled while the router is starting.
  • The maximum configurable delay is 5 minutes, equal to 300 seconds.

MD5: c2be68ebdd9b53adf0138daeac0f0563

Firmware

WMR-1.2.0.bin

  • Added support for a new device revision and improved sensor performance.
  • Added the item Permanenza Temporizzazione in the Relay Settings section.
  • Fixed a major Cloud connection bug for Water Meter Relay devices from R061 to R080.
  • Fixed a rare total device freeze bug.
  • Improved readability: AP SSID and host name become WMRele-{ID}.
  • Improved WiFi performance with networks having multiple Access Points with the same name.
  • Minor bug and performance fixes.

MD5: 33536e3859439e55d680e07b924c35f5